Where is the water pump located on a Kenmore washer?

Carefully tilt the washer forward and lay it on the front panel so that you can access the components from the bottom of the washer. Use pliers to release the spring clamp on the drain hose. Pull the drain hose off of the drain pump. Open the cover that protects the wire harness plug on the drain pump.

Carefully tilt the washer forward and lay it on the front panel so that you can access the components from the bottom of the washer. Use pliers to release the spring clamp on the drain hose. Pull the drain hose off of the drain pump. Open the cover that protects the wire harness plug on the drain pump.

One may also ask, how much does it cost to fix a washing machine pump? It can cost as little as $10 or as much as $75 or more. However, most homeowners pay between $25-$40 for a new pump. The other materials and tools you need include: Clamps.

Beside this, where is the water pump located on a washing machine?

The pump is usually located along the bottom of the machine, but with the unit tipped on its front, it’s easier to remove the pump through the back than through the bottom of the washer.

How do I know if my washing machine pump is bad?

If the motor and pump is running but no water is draining out then most likely the 3363394 pump is bad. One thing you can try first is to lower the drain hose over a shallow pan and see if the water in the tub will drain by gravity. If not then there may be a sock or other obstruction blocking the pump.

How much is a drain pump for a Kenmore washer?

Replaced the drain pump (W10130913) with this pump. It came with the pump motor, two wires with connections and a rubber seal as seen in the photo. Top Selected Products and Reviews. List Price: $49.95 You Save: $19.96 (40%)

How do you replace a drain pump on a Kenmore he2 washer?

Replace a Drain Pump in a Kenmore / Whirlpool Washer Step 1: Items Needed. You will need a few item to change the pump. Step 2: Unplug the Machine. Just a reminder to make sure power is off. Step 3: Remove Lower Front Panel. Step 4: Drain Washer. Step 5: Remove Old Pump and Motor. Step 6: Water in Motor Housing. Step 7: Connector Difference. Step 8: Wiring the Motor.

How do you replace a water pump on a Kenmore washing machine?

Step 2 Carefully remove both wire harnesses connected to the pump. Squeeze and pull back hose clamp. Twist drain hose off of pump. Using a 1/4″ socket wrench, remove the three mounting screws. Pull the pump out of place. Pulling the pump away takes a little force.